12dc6d1ac8
* Fix serial speed DD configuration - Fixes incorrect SOFT_SERIAL_SPEED mapping - Renames key split.soft_serial_speed -> split.serial.speed - Migrates keyoards that configure this, and remove configuration from keyboards that do not differ from the default behaviour - Add deprecation notice and migration support |
||
|---|---|---|
| .. | ||
| keymaps/default | ||
| rev1 | ||
| rev2 | ||
| config.h | ||
| halconf.h | ||
| info.json | ||
| mcuconf.h | ||
| readme.md | ||
grandiceps
ARM split keyboard with RGB underglow and encoders.
- Keyboard Maintainer: vattern
- Hardware Supported: f411 blackpill
- Hardware Availability: grandiceps
There are two versions of the Grandiceps. Please use the appropriate firmware for your board.
- Revision 2 has I2C eeprom and support for a Pimoroni trackball.
Make example for this keyboard (after setting up your build environment):
make tkw/grandiceps:default
make tkw/grandiceps/rev2:default
Flashing example for this keyboard:
make tkw/grandiceps:default:flash
make tkw/grandiceps/rev2:default:flash
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
Bootloader
Enter the bootloader in 3 ways:
- Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
- Physical reset buttons: Hold down the BOOT0 button and then briefly press the NRST button on the BlackPill PCB.
- Keycode in layout: Press the key mapped to
QK_BOOTif it is available